HME DX100 Portable Digital Wireless Intercom
HME DX100 Portable Digital Wireless Intercom
The DX100 allows up to 15 people to speak to each other via headsets without any interconnecting cables.
Much better than walkie-talkies – you can seamlessly communicate in hands-free mode or have a private conversation on a secured channel.
Simple and expandable, the DX100/100C comes complete with everything you need for reliable, cost-effective operation for any application.
SPECS:
Frequency Range: 2400 – 2483.5 MHz
Frequency Response: 200 Hz to 3.5 kHz
Power Requirements: 100-240VAC, 50-60Hz or 12-14VDC
Temperature Range: 32-122°F (0-50°C)
Size: 10.2” x 6.45” x 3.33” (1-RU) (25.91 x 16.38 x 8.46 cm)
Weight: 2.35 lbs. (1.07 kg)
Maximum # of Beltpacs per Base: 15 can be registered Any 4 can have simultaneous full-duplex communication at one time. Others would be listen-only until a channel becomes available.
Front Panel Controls: Power, Register Beltpac, Reset, Unlatch and Clear Registration buttons
Front Panel Indicators: Registration Status display, Power and Receive LEDs
Antenna Type: External ½ -wave dipole (R-TNC connector) RX/TX horizontal/vertical diversity
System Distortion: <2%
Communication Security: 64-bit encryption dual-slot diversity
Splash Resistant: IEC529 IP Code 4 (under battery operation only)
Transmitter
Type: Frequency hopping, spread spectrum
Transmit Power: 100mW burst
Modulation Type: Gaussian filtered FSK, TDM
Frequency Stability: 13 ppm
Harmonics/Spurious: Exceeds FCC and ETSI specifications over temperature
Receiver
Type: Frequency hopping, spread spectrum
RF Sensitivity: <−90dBm w 10-3 BER
Frequency Stability: 13 ppm
Distortion: <2%